Hydrostatic liquid level sensor PS-02-010

Submersible water pressure sensor. The pressure exerted by water on the sensor is transmitted as a voltage signal (0 ~ 10 V). The hydrostatic pressure is directly proportional to the submersion. The sensor is designed for operation in water. The pressure level sensor is usually mounted in a vertical position (e.g., in a well), hanging on a cable. Where the sensor may be exposed to movement during measurement, the position of the sensor must be secured to prevent errors. This can be done with a tube or weight placed on the probe.

Technical data

Dimensions

Application

Dedicated meters for sensors are MG14 meter/regulator with four alarm relays and large display, and SD8V panel meter/regulator with two alarm outputs from Termipol. Thanks to the combination of the measurement result display devices and the sensor, it is possible to continuously control the level with a single sensor. The sensor can be used in water, for example, in a well.

Example of application with pressure sensor and MG14 meter.

Step 1

Set the input signal type Sn = 12 (0~10 V) → see instructions para. 3.

Step 2

Set the minimum display value for the minimum value of the PUL input signal (we will set the display value for 0 V, e.g. 0).

Set the maximum display value for the maximum value of the PUH input signal (we will set the display value for 10 V e.g. 200).

Reading and monitoring the water level in the tank using the MG14 Panel Meter and the PS-05-010 hydrostatic sensor.

Example of application with pressure sensor and SD8V meter.

Step 1

Set the input signal type 1nP = 0_10 (0~10 V) → see instructions para. 1.

Step 2

Setting the minimum display value for the minimum value of the input signal FL = 0 (we will set the display value for 0 V, for example, 0).
Setting the maximum display value for the maximum input signal value FH = 3000 (we will set the display value for 10 V e.g. 3000).