
Fuel or high temperature liquid level sensor PS-B-02-010
597.56zł Tax excluded
Hydrostatic liquid level sensor PS-B-02-010
Submersible water pressure sensor. The pressure exerted by water on the sensor is transmitted as a voltage signal (0 ~ 10 V). The hydrostatic pressure is directly proportional to the immersion. The sensor is designed for use in fuels (diesel, gasoline) as well as in water and high-temperature liquids (up to 400°C). The sensor's capillary is made of SS 316L stainless steel. The signal of the measured liquid pressure is transmitted through a tube to the sensor, which is located in an external, airtight housing. This avoids contact with the measured liquid, which allows use in high-temperature liquids as well as fuels.

Technical data
Name | Description |
Output signal | 0 ~ 10 V |
Power supply | 12-24V |
Measuring range | 0 ~ 2m |
Working environment temperature | 0 ~ +400°C |
Protection degree | IP68 |
Construction material | SS 316L stainless steel |
Capillary length | 300cm |
Dimensions

Application
Dedicated meters for sensors are MG14 meter/regulator with four alarm relays and large display, and SD8V panel meter/regulator with two alarm outputs from Termipol. Thanks to the combination of the measurement result display devices and the sensor, it is possible to continuously control the level with a single sensor. The sensor can be used in water, for example, in a well.
Example of application with pressure sensor and MG14 meter.
Step 1
Set the input signal type Sn = 12 (0~10 V) → see instructions para. 3.
Step 2
Set the minimum display value for the minimum value of the PUL input signal (we will set the display value for 0 V, e.g. 0).
Set the maximum display value for the maximum value of the PUH input signal (we will set the display value for 10 V e.g. 200).


Fig

Reading and monitoring of fuel level in the tank using MG14 panel meter and PS-B-02-010 hydrostatic sensor.
Example of application with pressure sensor and SD8V meter.
Step 1
Set the input signal type 1nP = 0_10 (0~10 V) → see instructions para. 1.
Step 2
Set the minimum display value for the minimum input signal value FL = 0 (we will set the display value for 0 V e.g. 0).
Set the maximum display value for the maximum input signal value FH = 3000 (we will set the display value for 10 V e.g. 3000).

Technical data
- Power supply:
- 12 - 24 VDC
- Operating temperature:
- 0 ~ +400 °C
- Degree of protection:
- IP68
- Materiał wykonania:
- Stal nierdzewna SS 316L
- Długość przewodów:
- 300cm
- Mounting:
- No
- Output signal:
- 0-10 V
- Measurement medium:
- Benzyna, Olej napędowy, woda
Add a review
Add a review