Liquid level sensor HT275-2
91.87zł Tax excluded
Liquid level sensor HT-275-2
They are used wherever it is necessary to control and regulate the level of liquid (such as water, oil, etc.). The sensor has two floats equipped with a magnet, which move vertically along the guide tube under the influence of the buoyancy force of the liquid, causing the reed switch to short circuit or open. They are usually mounted in the bottom or lid of the tank, so they can be used to control the lower or upper level of the liquid. By changing the position of the float, the function of the reed switch is changed from short-circuited to open-circuited.
|Max. switching voltage||100VDC|
|Max. switching current||0,5A|
|Operating temperature||-30 ~ +125 °C|
|Protection degree||IP 67|
|Cable length||30 cm|
|Material||Stainless steel SUS304|
|Mounting||External thread with nut M10|
|Attestation||PZH approval - approved for contact with drinking water|
The design of the sensor does not allow the connection of 230V mains voltage, so it is recommended to use the relay AFR1 with a built-in safe voltage source of 8VAC to power the sensors.
Principle of operation
The sensors have a magnet fixed in the float, which by rising causes the contact of the reed switch, located in the body of the tube, to short or open. The sensors can operate as NC - normally closed or NO - normally open. Changing the mode of operation is achieved by rotating the float by 180°.
Example of application
Maintaining the level of liquid in a tank at any level, high and low, using the relay AFR1 available on our other auction. Relay AFR1 Allows both the actuation of an actuating device (e.g. pump, solenoid valve) and the supply of up to two sensors with low control voltage.
Maintain the level of liquid in the tank at any level, high and low using the relay AFR1.
- External thread with M10 nut
- Switching voltage
- 100V DC
- Max. prąd przełączania
- 0,5 A
- Długość przewodów
- 30 cm
- Materiał wykonania
- Stainless steel SUS304
Add a review
Add a review