Liquid level sensor HT-ZPC4

They are used wherever it is necessary to control and regulate the level of liquid (such as water, oil, etc.). The sensor has a float equipped with a magnet that moves vertically along the guide tube under the influence of the buoyancy force of the liquid, causing the reed switch to short circuit or open. They are usually mounted in the bottom or lid of the tank, so they can be used to control the lower or upper level of the liquid. By changing the position of the float, the function of the reed switch is changed from short-circuited to open-circuited.

Technical specifications

Note

The design of the sensor does not allow the connection of 230V mains voltage, so it is recommended to use the relay AFR1 with a built-in safe voltage source of 8VAC to power the sensors.

Principle of operation

The sensors have a magnet fixed in the float, which, when raised, causes the contact of the reed switch, located in the body of the tube, to short or open. The sensors can operate as NC - normally closed or NO - normally open. Changing the mode of operation is achieved by rotating the float by 180°.

high state: off low state: on	high state: on low state: off

Example of application

Maintaining the level of liquid in a tank at any level, high and low, using the relay AFR1 available on our other auction. Relay AFR1 Allows both the actuation of an actuating device (e.g. pump, solenoid valve) and the supply of up to two sensors with low control voltage.