HT19 M10 liquid level sensor
108.13zł Tax excluded
Liquid level sensor HT-19-M10
They are used wherever it is necessary to control and regulate the level of liquids (such as water, oil, etc.). The sensor has a float equipped with a magnet that rises or falls under the buoyancy force of the liquid, causing the reed switch to short or open. They are usually mounted in the bottom or lid of the tank, so they can be used to control the lower or upper level of the liquid. By changing the position of the float, the function of the reed switch is changed from short-circuited to open-circuited.
|Max. switching voltage||100VDC|
|Max. switching current||0,5A|
|Operating temperature||-30 ~ +125 °C|
|Protection degree||IP 67|
|Material||Stainless steel SUS304|
|Mounting||External thread m10a|
|Attestation||PZH approval - approved for contact with drinking water|
The design of the sensor does not allow the connection of 230V mains voltage, so it is recommended to use the relay AFR1 with a built-in safe voltage source of 8VAC to power the sensors.
Principle of operation
The sensors have a magnet fixed in the float, which by rising causes the contact of the reed switch located in the body of the tube to short or open. The sensors can operate as NC - normally closed or NO - normally open. Changing the mode of operation is achieved by rotating the float by 180°.
Example of application
Maintain the level of liquid in the tank at any levels, high and low, using the relay AFR1 available in our store. Relay AFR1 Allows both the actuation of an actuator device (such as a pump, solenoid valve) and the supply of up to two sensors with low control voltage.
Maintain the level of liquid in a tank at any level, high or low, using the AFR1 relay.
- External thread with M10 nut
- Switching voltage
- 100V DC
- Max. prąd przełączania
- 0,5 A
- Breakdown voltage
- 220V DC
- Długość przewodów
- 30 cm
- Materiał wykonania
- Stainless steel SUS304
Add a review
Add a review