Float switch, liquid level, reed switch, M12 thread mounting. Made of PP (Polypropylene).
The product is shipped within 24 hours.
We complete the order within 24 hours.
The product is covered by a one-year warranty.
You can return the product within 14 days.
Output: | NO |
Max. Load: | 0,5 A |
Accuracy of measurement: | +/- 1 cm |
Material of execution: | Polypropylene |
Mounting: | Gwint M12 |
Number of wires: | 2 |
Assembly: | Side |
Measurement: | Water |
Sensor: | Pływakowy |
Working voltage: | do 100 VDC |
Degree of Protection: | IP 67 |
Wire lengh: | 30 cm |
Working Conditions: | -10 ~ 85 °C |
Ilość pływaków: | 1 |
They are used wherever control and regulation of the liquid level is necessary (e.g. water, oil, etc.). Resistant to acids and bases. The sensor has a float equipped with a magnet, which moves vertically along the guide tube under the influence of the buoyancy force of the liquid, causing the contactor to close or open. They are usually mounted in the tank cover, so they can be used to control the upper liquid level.
The sensor design does not allow for connection of 230V mains voltage, so it is recommended to use AFR1 relay with built-in safe 8VAC voltage source for powering the sensors.
Sensors have a magnet mounted on the float, which when rising causes the contact of the reed switch located in the tube body to close or open. The sensors can work as NO - normally open.
Maintaining the liquid level in the tank at any levels, high and low, using the AFR1 relay available on our other auction. The AFR1 relay allows both the activation of the actuator (e.g. pump, solenoid valve) and the supply of two sensors with a low control voltage.
Maintaining the liquid level in the tank at any levels, high and low, using the AFR1 relay.