Float switch, liquid level, reed switch, M10 mounting. Made of stainless steel.
The product is shipped within 24 hours.
We complete the order within 24 hours.
The product is covered by a one-year warranty.
You can return the product within 14 days.
Max. Load: | 0,5 A |
Sensor wire: | Brak |
Material of execution: | Stainless Steel |
Mounting: | Gwint M10 |
Assembly: | Side |
Measurement: | Water |
Sensor: | Contractual, Pływakowy |
Working voltage: | do 100 VDC |
Degree of Protection: | IP 67 |
Working Conditions: | -30 ~ 125 °C |
Ilość pływaków: | 1 |
Additional Information: | Approved PZH for contact with drinking water |
They are used wherever a control and regulation of the liquid level (e.g. water, oil, etc.) is necessary. The sensor has a float equipped with a magnet, which rises or falls under the influence of the buoyancy force of the liquid, causing the contactor to close or open. They are usually mounted in the bottom or cover of the tank, so they can be used to control the lower or upper level of the liquid. By changing the position of the float, the function of the contactor is changed from closed to open.
The design of the sensor does not allow for the connection of mains voltage 230V, so for the power supply of the sensors it is recommended to use the AFR1 relay with an integrated safe voltage source 8VAC.
Sensors have a magnet mounted on the float, which, when rising, causes the contactor switch located in the tube body to close or open. Sensors can work as NC - normally closed or NO - normally open. We obtain a change of mode by turning the float by 180°.
![]() |
![]() |
|
|
Maintaining the level of liquid in the tank at any levels, high and low, using the AFR1 relay available in our store. The AFR1 relay allows both the activation of the actuator (e.g. pump, solenoid valve) and the supply of two sensors with a low control voltage.
Maintaining the level of liquid in the tank at any levels, high and low, using the AFR1 relay.